What exactly are dimensional tolerances, basic dimensions, and limit dimensions?

What exactly are dimensional tolerances, basic dimensions, and limit dimensions?

In the process of bearing selection and installation, we often encounter technical terms such as "dimensional tolerances," "basic dimensions," and "limit dimensions." These may sound like engineering concepts, but understanding them is crucial for improving assembly accuracy and extending bearing life. Today, let's clarify these three key terms together!

I. What is a Basic Dimension?

A basic dimension is the theoretical dimension of a part as marked on the design drawings, or the dimension under "ideal conditions." For example, the inner diameter of a bearing is marked as 50mm; this 50mm is its basic dimension.

It is the starting point for design;

However, in actual machining, it is difficult to achieve this value 100%;

Therefore, "tolerances" and "limit dimensions" exist.

II. What is Dimensional Tolerance?

We all know that machining cannot achieve "absolute precision." Even the most precise equipment will have a certain degree of error. The allowable range of this error is the dimensional tolerance.

Dimensional tolerance = Upper deviation value - Lower deviation value. It specifies the maximum allowable range of fluctuation in the part's dimension.

For example, if the basic dimension of a hole is 50mm, and its allowable range is +0.02 / -0.01mm, then its dimensional tolerance is 0.03mm.

Tolerances are not arbitrarily given; they are based on national standards (such as ISO, GB, etc.). Different tolerance grades represent different precision requirements.

III. What are Limit Dimensions?

Limit dimensions are the upper and lower limits of a size calculated based on the "basic size" and "dimensional tolerance."

Continuing with the example above:

* Basic size: 50mm

* Tolerance: +0.02/-0.01mm

Then its limit dimensions are:

* Maximum limit dimension = 50 + 0.02 = 50.02mm

* Minimum limit dimension = 50 - 0.01 = 49.99mm

In other words, as long as the actual size falls between 49.99mm and 50.02mm, the part is considered (qualified/acceptable).

Why are these dimensional requirements so important for bearings?

Bearings, as high-precision components, have extremely high requirements for installation dimensions. Excessive dimensional deviations can lead to the following problems:

* Excessive clearance: Affects operational accuracy and causes vibration;

* Overly tight fit: Increases friction, leading to overheating or even seizing;

* Accelerated wear: Reduces bearing life;

* Difficult installation: Affects assembly efficiency and cost.

Therefore, understanding bearing dimensional tolerances and limit dimensions is a fundamental skill for every purchasing and engineering professional!